Dynacraft ELECTRIC POWER SCOOTER Manuel du propriétaire

HELLO KITTY CITY SCOOTERTHIS MANUAL CONTAINS IMPORTANT SAFETY , PERFORMANCE AND MAINTENANCE INFORMATION . READ THE MANUAL BEFORE TAKING YOU

9ASSEMBLY WARNING Children can be harmed by small parts, sharp edges and sharp points in the vehicle’s unassembled state, or by electrical items. WARN

10Attaching the Front Fender to the Front Fork1. Use a Phillips screwdriver to attach and tighten the front fender with the two screws and mounting br

113. Insert the tab on the lock washer into the hole on the front fork and tighten the nuts using two 15mm wrenches. WARNING Make sure that once the n

12 WARNING Rechargeable batteries are only to be charged under adult supervision. Always disconnect your scooter from the charger before cleaning wit

13BEFORE YOU RIDE AND ROUTINE SAFETY CHECKSBefore you ride always check for the following:Safety Gear Always wear proper protective gear such as:• Ap

14Pre-Ride ChecklistLoose PartsThere should not be any unusual rattles or sounds from loose parts or broken components. If you are not sure, ask an ex

15DETAILED MAINTENANCE AND REPAIR(Turn power “OFF” before conducting any maintenance procedures)Testing the BrakesTo use the brake, squeeze the lever

16 WARNING The brake could be capable of skidding the tire and causing the rider to loose control and fall or be thrown from the scooter if not applie

173. With a 10mm wrench, loosen the brake cable anchor and disconnect the cable.Note: Get all the anchor hardware out of the brake arm hole and keep t

186. Slide the chain onto the chain wheel as shown. Then slide the rear wheel axle into the slots on the rear end of the frame. (Replace with a new ch

1TABLE OF CONTENTSA Introduction, Safety and Warnings B Before You Begin As

199. Re-attach the chain guard. Test ride and readjust as needed.Chain Tensioner Replacement:Note: Use a Phillips screwdriver to remove the 4 bolts fr

20BATTERY CARE AND DISPOSALDo not store the battery in temperatures above 75° F (23.5° C) or below 32° F(0°C).THIS SCOOTER CONTAINS SEALED LEAD ACID B

21ProblemScooter does not runScooter suddenly stops while in useShort run time (less than 15 minutes per charge)Possible CauseUndercharged batteryLoos

22ProblemScooter runs sluggishlySometimes the scooter doesn’t run, but other times it doesScooter makes loud noises or grinding soundsCharger is unabl

23WARRANTYLimited WarrantySubject to the following limitations, all electric scooters manufactured for Dynacraft are warranted to the original purchas

24SB 1918/Cal. Veh. Code, §§ 406, 407.5 (CALIFORNIA) DISCLOSUREYOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF TH

25Cal. Veh. Code, § 407.5 (CALIFORNIA) DISCLOSURE (IF APPLICABLE) YOU MAY NOT MODIFY OR ALTER THE EXHAUST SYSTEM OF THIS SCOOTER TO CAUSE IT TO AMPLIF

26Dynacraft Customer Service1.800.288-15607AM TO 4PM PACIFIC TIMEPlease have the following information available when you call:Model Number:

2INTRODUCTION, SAFETY, AND WARNINGSABOUT THIS MANUAL: This Manual was written to help you get the most performance, comfort, enjoyment and safety when

3Always wear appropriate clothing and shoes, including long sleeved shirts and long pants and lace-up or similar shoes with rubber soles. Never ride

4• Children must be supervised by an adult to be safe.• Always be alert and ride your scooter defensively. Watch out for obstacles that could catch

5• Before each cycle of operation, the operator shall perform the pre-operation checks specified in this manual or by the manufacturer, including:• T

6USING THE CHARGER The charger should be examined regularly for damage to the cord, plug, enclosure and other parts. In the event such damage has occu

7Required ToolsIf you experience a problem with this product, or are missing a part, please call us at 1-800-288-1560, rather than return this product

8CITY SCOOTER PARTS 1. Handlebar Grip (Right/Left) 2. Single Speed Twist Grip Throttle3. Handlebar4. 6mm Stem Bolt