Dynacraft ELECTRIC POWER SCOOTER Manuel du propriétaire

OFF-ROAD ELECTRIC SCOOTERthis manual contains important safety, performance and maintenance information. read the manual before taking your first ride

10Handlebar AssemblyTools Required: 5mm Allen Key (included).Attach the handlebar onto the handlebar steerer tube as shown, and tighten the handle-bar

11Charging the BatteryYour off-road electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery prior to

12charge status. Refer to the illustration on the charger unit for the actual “charging” and “charged” status indications for your model charger. Char

13Battery: Always make sure the power switch is in the “off” position whenever the off-road electric scooter is not in use. Never store the product in

14Front Wheel ReplacementTools required: 12mm wrench & 17mm wrench (not included)1. Using a 12mm wrench and a 17mm wrench, loosen the front wheel

15Chain, Rear Brake and Rear Wheel ReplacementTools required: Phillips screwdriver, 8mm wrench, 10mm wrench, 12mm wrench and 17mm wrench (not include

16fig. 7-3fig. 7-2fig. 7-1Remove rear wheel for replacement (or replace with new rear brake or new chain at this time).Note: Rear wheel hardware sequence

1711. Tighten the 4 screws on the chain guard with a Phillips screwdriver.Adjust Chain Tightness1. Use a Philips Screwdriver to loosen the brake housi

18Battery Care and DisposalDo not store the battery in temperatures above 75°F (23.5°C) or below 32°F(0°C).THIS OFF-ROAD ELECTRIC SCOOTER CONTAINS SEA

19ChargerThe charger supplied with the off-road electric scooter should be regularly examined for damage to the cord, plug, enclosure and other parts.

2TABLE OF CONTENTSIntroduction, Safety and WarningsBefore You Begin AssemblyOff-Road Electric Scooter PartsAssemblyBefore You RideDetailed Maintenance

20TROUBLESHOOTING GUIDEProblemOff-road electric scooter will not run Off-road electric scooter suddenly stops working while in usePossible Cause Char

21ProblemOff-road electric scooter runs sluggishlySometimes the off-road electric scooter doesn’t run, but other times it doesOff-road electric scoo

22WARRANTYLimited WarrantySubject to the following limitations, all off-road electric scooters manufactured for Dynacraft are warranted to the origina

23SB 1918/Cal. Veh. Code, §§ 406, 407.5 (CALIFORNIA) DISCLOSUREYOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THI

24Cal. Veh. Code, § 407.5 (CALIFORNIA) DISCLOSURE (IF APPLICABLE) YOU MAY NOT MODIFY OR ALTER THE EXHAUST SYSTEM OF THIS OFF-ROAD ELECTRIC SCOOTER TO

25

26

27

Dynacraft Customer Service1.800.288-15607AM TO 4PM PACIFIC TIMEPlease have the following information available when you call:Model Number: (sample: 85

3INTRODUCTION, SAFETY, AND WARNINGSABOUT THIS MANUAL: This manual was written to help you get the most performance, comfort, enjoyment and safety when

4Always wear appropriate clothing and shoes, including long sleeved shirts and long pants and lace-up or similar shoes with rubber soles. Never ride b

5• Children must be supervised by an adult to be safe.• Always be alert and ride your off-road electric scooter defensively. Watch out for obstacles

6• Do not to allow hands, feet, hair, body parts, clothing, or similar articles to come in contact with moving parts, wheels, or drivetrain, while th

7USING THE CHARGERThe charger should be examined regularly for damage to the cord, plug, enclosure and other parts. In the event such damage has occur

8OFF-ROAD ELECTRIC SCOOTER PARTSPart Description1. Handlebar Grip (Right / Left)2. Variable Speed Twist3. Handlebar Clamp4. Handlebar5. Brak

9Scooter Body and Front Fork AssemblyTools Required: 13mm wrench & 17mm wrench (not included)1 Insert the stem (assembled with the front fork, fr